Could be vt6421 linux one used for 64 vt6421 linux OS vista. VT6421A Serial RAID Controller Thanks for your attention about this controller and OS combination. When you tell it to use a IDE (ATA) controller It will look for PATA/ATA Hard drives, then will not find it, and will not load the drive- thus Windows does not load. VX855/VX875 Integrated Serial ATA RAID controller Instructions: To install the driver, save any unsaved work and close all applications then click on the driver download link (above). I would check your device manager for the storage controller, It should be a SCSI (if it wasnt Windows would not see your drive, and thus not load it). Unless you switched your HDD in the BIOS from ACHI to IDE, I dont know why you would be using a IDE storage controller for a SATA drive. Legacy-mode is a software backward-compatibility mechanism intended to allow the SATA-controller to run in legacy operating-systems which are not SATA-aware. Intel recommends choosing RAID mode on their motherboards (which also enables AHCI) rather than the plain AHCI/SATA mode for maximum flexibility, due to the issues caused when the mode is switched once an operating system has already been installed. Many SATA controllers offer selectable modes of operation: legacy Parallel ATA, standard AHCI-mode, or vendor-specific RAID. Evidently you have a onboard SATA controller otherwise your SATA HDD would not load (unless switched to IDE mode) It is a controller for IDE drives.įor VT6410, which is an IDE RAID controller, use ATA HDDs (not SATA)-or dont use this controller. The reason it wont or boot off your SATA drive when you connect it, is because it is not a SATA controller.
0 kommentar(er)
